How to Select a Three Phase Separator for Oilfield Application

In actual field operations, production behavior is often far less stable than expected. Gas rate fluctuates, water cut increases earlier than forecast, and solids may appear once the well begins to clean up.

HC Advances UAE Project with Insulation Completion of Skid-Mounted Water Bath Heater

Last night, insulation work was completed on the skid-mounted water bath heater currently under fabrication for a UAE project. With this step finished, the unit is gradually taking its final shape on the workshop floor.

HC Reaches New Cooperation with European Client on Shell and Tube Heat Exchangers

Recently, HC reached a new cooperation agreement with a European client for the supply of two shell and tube heat exchangers. The equipment will be used in an industrial heat transfer system,

Early Production Facility Solutions Built on Practical Engineering Experience

Over the years, HC has supplied equipment for early production facilities in a variety of operating environments. Feedback from field operations consistently shows that simple

Oil and Gas Separators RFQ: What Information Should Be Provided to the Manufacturer?

From HC’s experience working with operators and EPC contractors, the efficiency of the quotation and technical evaluation process depends largely on whether the right information is prepared and shared upfront.

Three Phase Separator Selection: Practical Considerations from Field Experience

In many cases, unstable liquid levels, intermittent carryover, or downstream fouling are not caused by poor operation, but by design assumptions that did not fully reflect how the well would actually produce.

Customized Desander Package for Kazakhstan Oilfield Applications

In oil and gas field surface facilities, one of the most frequently asked questions from operators is simple but critical: how to remove sand efficiently without affecting system stability.

Customized Shell and Tube Heat Exchanger for Syria Project

HC has recently completed the design and fabrication of a customized shell and tube heat exchanger for a client in Syria.The equipment was specifically engineered to meet the project’s operating conditions and site requirements